Tuesday, May 24, 2016

Xperia Z Dd Boot Repair C6602 / C6603 / C6606 / C6616


Xperia Z Dd Boot Repair C6602 / C6603 / C6606 / C6616
Bricked phone symptoms: can't power on after flash,no l or led rction for power button,no l or led rction for charger,no l or led rction if phone is connected to PC,your PC can't detect your phone with vol-,phone does not vibrate when holding vol+ and power together.Download and run this s1tool: Download


Download Boot repair File Here



Test point For C6602





Note : For Other models find test point nd post here


Repair procedure:
Firstly connect turned off bricked phone to your PC. If phone will be detected in device manager as

:qhusb_dload deviceyou are lucky and this is the end of the first step for you. Just disconnect phone.

If your phone can't be detected at all, you must find testpoint. Disassemble your phone
remove battery and connect ch golden point on main board one by one to metal shield and attach usb cable. If your phone will be detected in device manager as flash device or something like that you've found testpoint. Don't forget to take a picture of main board and mark testpoint nd post here

In S1tool choose S1 EMERCY MODE, press Flash button, select correct APPSW .sin_file_set file (or you can select whole firmware if you have it in order APPSW, FSP, Elabel .

Press Testpoint RDY button



and if your phone is detected as qhusb_dload device, just attach usb cable. If not, perform all steps from point 1 (connect testpoint to GND and attach USB cable).

When drivers will be installed and phone will be detected, program will ask you to disconnect testpoint. Disconnect testpoint from GND and press Testpoint RDY button.

After that phone will load emercy s1 loader, re-enumerate usb, load s1 loader, update boot in your phone and flash selected firmware.

After done flash vit full firmware using Fastboot

Credits goes to :juriji
Source: .yt

No comments:

Post a Comment